Had A Face To Face With Your Attic Insulation Lately?
It’s not really hard to determine whether an old home needs new attic insulation. If there is room enough to get a look in the attic it’s pretty easy to tell. Recently we purchased an historic 1940’s era home for use as an office.
Old batts had settled and deteriorated.
Going in it was clear the property needed renovation. A look in the attic confirmed a major upgrade item would be insulation. The old fiberglass batts had settled well below the tops of the joists and the overall coverage was providing limited insulation (RValue) at best. This also provided an excellent opportunity for me to personally experience the retrofit insulation process from a consumer perspective. Here’s a recap of that experience:
Selecting Insulation and Installer:
My goal was to increase the insulation to R-30 for long-term energy savings and to obtain a rebate from the local utility company. The best options were to add another layer of fiberglass batts or to have fiberglass or cellulose blown in. I decided to blow in insulation. It would be more expensive but provide much better coverage and help to control air infiltration. I obtained bids from three reputable insulation contractors and was surprised to learn that their was no difference in price between cellulose and fiberglass. After reviewing references on each I select the mid-priced bidder and chose cellulose for it’s environmental benefits and excellent insulating characteristics.
Once the job was scheduled it was time to take a harder look in the attic. It was important to inspect and make any repairs before almost 10 inches of cellulose insulation was blown over the old batts and everything else. I suited up in protective gear (their was quite a bit of “fiberglass dust” from the existing batts in the attic) and cleared out old items, shored up A/C ducts and made other minor repairs and preparation. Then, prior to installation day I also covered the just-restored original wood floors with 6mil visqueen. The attic access was in the bathroom ceiling accessible via a long hallway from the front door.
After Cellulose Insulation Install
My insulation contractor did an excellent job. Their three-man crew closed off the doorway between the hall and bathroom with more visqueen. Then they carefully ran their blower hose through an opening and up into the attic. The job took about three hours and 40 bags of cellulose insulation for my 1,030 square foot house. There was no spilled cellulose and surprising very little fiber dust. A quick run of the vacuum in the bathroom was all the clean up required.
Cost & Outcome:
My cost after the rebate was $410.00. It will be a few months before I can compare utility bills but I feel this was an excellent investment in my property. We have already noticed the house is much quieter and the inside air temperature is more stable. Overall, after just a few weeks, the living environment has clearly improved.
Maybe it’s time to look in your attic. If you haven’t recently it probably will raise questions. Leave them in the Reply box below and we’ll try to provide answers. Have your own insulation story? Share it in the Reply Box with our readers.
(Jim Doyle works with CIMA Executive Director Dan Lea to write and edit the Greenest Insulation Blog. His office referenced in this story is in Jacksonville Florida.)